Product Parameters
1.The clarifying agent kit is sold separately.
2.A customized mode will be added by OTA through the APP. Users will be able to tailor their cleaning by choosing the area or combination of areas they want to clean.They will also be able to choose to clean only the surface or only the waterline, and set the cleaning cycle to their preference (1 or 2 times).
3.The water flow rate is measured in GPH (gallons per hour). The stronger the water pump flow capacity, the higher the suction power, and consequently, the greater the success rate of climbing walls. Please note that 5500GPH was the highest rate tested in Beatbot's internal labs, so actual results may vary.
For AquaSense Pro
For AquaSense
Yes, our robot can be safely used in salt water with a concentration not exceeding 5000 ppm. The concentration of salt in most home swimming pools does not exceed the above concentrations.
AquaSense Pro comes with a two-layer filter that can effectively capture debris of all sizes, including leaves, hair, sand, insects, and more. It can filter particles as small as 150 micrometers (μm).
It is suitable for swimming pools of various shapes and made of vinyl, fiberalass, ceramic or other materials.
Aquasense Pro can complete water surface cleaning for up to 9.5 hours or pool bottom cleaning for up to 5 hours in a single charging cycle.The above data are the test results of Beatbot laboratory, and the details are always subject to the actual operating environment.
AquaSense Pro can work with beach entry pools as long as the water depth is over 1.6ft, as AquaSense Pro is designed to operate within a depth range of 1.6ft to 9.8ft. If the water depth is less than 1.6ft, then the robot will return to the water of deep side.
No need to dry the robot, as long as there is no excess salt in the pool water and the pH is neutral, if not please ranise the robot first.
Yes, the robot can work without WI-Fi. The modes on the robot can cover the cleaning of all areas, please check and select the corresponding mode before starting.
Yes, it works on both in-ground and above ground pools.
The filter basket's capacity of AquaSense Pro is 3.7L.
AquaSense Pro is equiped with 10,400mAh battery and it requires only 3.5 hours for a full recharge. The charging time may longer when temperature is below 77℉.
Yes, our robot can be safely used in salt water with a concentration not exceeding 5000 ppm. The concentration of salt in most home swimming pools does not exceed the above concentrations.
It is suitable for swimming pools of various shapes and made of vinyl, fiberalass, ceramic or other materials.
AquaSense can support cleaning time of up to 3.5 hours in quick mode (bottom cleaning) and 2.5 hours in standard mode (bottom + walls cleaning). The above data are the test results of Beatbot laboratory, and the details are always subject to the actual operating environment.
No need to dry the robot, as long as there is no excess salt in the pool water and the pH is neutral, if not please ranise the robot first.
Yes, the robot can work without WI-Fi. The modes on the robot can cover the cleaning of all areas, please check and select the corresponding mode before starting.
Yes, it works on both in-ground and above ground pools.
The filter basket's capacity of AquaSense is 2L.
AquaSense is equiped with 6700mAh battery and needs about 3hrs charging. The charging time may longer when temperature is below 77℉.